Connect with us

Xbee s2 cannot be detected with X-CTU

Discussion in 'Radio and Wireless' started by zazas321, Oct 1, 2018.

  1. zazas321

    zazas321

    6
    0
    Oct 1, 2018
    Hello guys. So I have received 2 Xbee s2 microcontrollers. They both been used by someone before. I am currently trying to configure them through X-CTU. I am also using UartSBee v.4.0 shield so I can easily connect microcontroller to PC USB. I have just finished 40 minutes scan(check screenshots) detect my Xbee but it was not able detect any devices. I have tried to scan it whilst connected to arduino but same results. Anything else should i try before i request new microcontrollers becuase these bad boys are expensive :eek:
     

    Attached Files:

  2. Nisar-von-Voltenbräackter

    Nisar-von-Voltenbräackter

    36
    3
    May 23, 2018
    Have you ensured your system to be TTL or CMOS and the controller chips compatible?
     
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.