Maker Pro
Maker Pro

Wiring/Base diagram for Hamamatsu R647 PMT

S

Sam Goldwasser

Jan 1, 1970
0
Hamamatsu doesn't seem to have any info like this on its Web site.

I'm fairly sure I've figured it out but need to confirm wiring of
existing PCB.

Thanks.

--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.
 
D

doug

Jan 1, 1970
0
Sam said:
Hamamatsu doesn't seem to have any info like this on its Web site.

I'm fairly sure I've figured it out but need to confirm wiring of
existing PCB.

Thanks.

--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.
Hamamatsu have (had) a .pdf catalog which lists this pmt
Pinout is pin 1 is DY1
pin 2 is DY3
pin 3 is DY5
pin 4 is DY7
pin 5 is DY9
pin 6 is P
pin 7 is DY10
pin 8 is DY8
pin 9 is DY6
pin 10 is DY4
pin 11 is DY2
pin 12 is IC
pin 13 is K
 
Top