Maker Pro
Maker Pro

Wireless Lan

S

Syd

Jan 1, 1970
0
I to want to input an RS232 Serial or USB signal into a wireless device to
be received by a PC on a 802.11 wireless network.
The wireless device should be portable and be battery operated.

Does anyone have a circuit or is there a commercial module that can do this?

Your help would be greatly apprecviated.
 
J

Jasen

Jan 1, 1970
0
I to want to input an RS232 Serial or USB signal into a wireless device to
be received by a PC on a 802.11 wireless network.
The wireless device should be portable and be battery operated.

Does anyone have a circuit or is there a commercial module that can do this?

It's called a laptop computer.

get a used one with a busted screen if cost is an issue.

Bye.
Jasen
 
J

jcomeau_ictx

Jan 1, 1970
0
I to want to input an RS232 Serial or USB signal into a wireless device to
be received by a PC on a 802.11 wireless network.
The wireless device should be portable and be battery operated.
Does anyone have a circuit or is there a commercial module that can do this?

A linksys WUSB54G might work. You'll need to do some programming, or
have it done for you, though. There are open-source (Linux) drivers
for its Ralink chipset. It gets its power off the USB port, wouldn't
that work as well as batteries? There's also the BGW200 module, but
that's even more work.
 
S

Syd

Jan 1, 1970
0
I would like to build the device rather than using a Laptop, Phone, Pocket
Pc etc. using modules possibly.
Will try and fit it into as small an enclosure as possible andl write the
software with some help.
 
J

John

Jan 1, 1970
0
Top