Jelsontronix
- Jan 17, 2015
- 1
- Joined
- Jan 17, 2015
- Messages
- 1
The wire antennae for my son's remote controlled truck was ripped out today. I took apart the controller and I could not determine where the wire was attached at in the first place. The range of the controller has been significantly reduced, so it seems that it was definitely attached to something and not just cosmetic.
I am thinking it was perhaps soldered into the big glob at R12 and R13 on the right side of the board.
Any ideas?
I am thinking it was perhaps soldered into the big glob at R12 and R13 on the right side of the board.
Any ideas?