Connect with us

Wire an Enforcer retro-reflective photoelectric beam sensor to a siren

Discussion in 'Sensors and Actuators' started by santiago, Dec 5, 2016.

Scroll to continue with content
  1. santiago

    santiago

    1
    0
    Dec 5, 2016
    Can someone inform me how to connect an Enforcer retro-reflective photoelectric beam sensor to a siren. The sensor has 5 wires of the following colors : brown, blue in the multi-voltage circuit ( 24-240 VAC or 12-240 VCD, polarity not important) and a gray (NC), white (Com), black (NO) in the Relay Output. I don't understand electronic diagrams so I would appreciate if you could inform me how to wire by cable color. Ex: The brown cable with the hot wire, the blue with ...... I have tried different combinations without success. Also, can you tell me if when the beam is activated will the siren keep activated or will it stop when the beam returns to normal after the object that interrupted the beam is removed? If so, can a shut of 60 seconds 8 pin timer be installed? How would I wire it?
     
  2. hevans1944

    hevans1944 Hop - AC8NS

    4,273
    2,012
    Jun 21, 2012
    Visit this page and then tell us what you actually have.
     
  3. the great potato

    the great potato

    47
    0
    Dec 2, 2016
    sounds like a kip key project, have you emailed him?
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-