S
someone
- Jan 1, 1970
- 0
The microwave (mdl MH7140XF) is reporting a F6 failure. (new 2001)
I have completed only the basic power off/on trouble shooting.
A whirlpool parts provider indicated the failure code does not relate to one
relay, rather a number of sensors.
While troubleshooting with power on/off cycles at one time the magnetron
started and did not shut off.
This microwave was subject to a recall and was opened and resealed ~ 2 years
back.
I suspect too much steam entered the area of the control board.
What would I look for re failure point?
I have completed only the basic power off/on trouble shooting.
A whirlpool parts provider indicated the failure code does not relate to one
relay, rather a number of sensors.
While troubleshooting with power on/off cycles at one time the magnetron
started and did not shut off.
This microwave was subject to a recall and was opened and resealed ~ 2 years
back.
I suspect too much steam entered the area of the control board.
What would I look for re failure point?