Maker Pro
Maker Pro

Whirlpool Dishwasher

E

Exbrat

Jan 1, 1970
0
I am trying to find a circuit diagram or a parts catalogue for a Whirlpool
dishwasher model ADG/1 (United Kingdom). I am troubleshooting an
intermittent fault where machine fails to fill. Solenoid water valve appears
OK. Any advice would be appreciated.
Regards. Dick.
 
C

Curmudgeon

Jan 1, 1970
0
"intermittent" would seem to be the key word. That means it could still be
the fill solenoid. I'd replace it just on general principle....cheap and
easy...and if it doesn't solve the problem, then you're looking at at the
part that sends the solenoid its signal....the timer/function unit.

You could also check that the overflow switch is operating freely. Not
likely stuck, but possible.
 
J

Jim Adney

Jan 1, 1970
0
I have taken apart the fill valve on my Whirlpool dishwasher many
times. It seems to build up some corrosion on the moving piston which
limits its motion, leading to these same symptoms. This always fixes
it for a few years and then I get to do it all over again.

-
 
Top