Connect with us

Which pcb editor should I use, adn where can I get my pcb's produced ?

Reply to Thread

Discussion in 'Electronic Basics' started by capitano, Jul 24, 2003.

Scroll to continue with content
  1. Jul 24, 2003 #1
    capitano

    capitano Guest

    Hello all,
    As I have not done it before I need to ask which pcb layout program
    most low-cost users use. What is the best free one or do I need to
    seriously considering paying for one. Is orcad still considerd the best
    and is it very expensive for a beginner. Also, since I don't want to etch
    myself with all those toxic substances, is there a company that will etch
    just one board, and if so, will it be sufficient to give then the pcb file
    or will they tell me to use any particular pcb designer ?
     
  2. Jul 24, 2003 #2
    Christian HOSTELET

    Christian HOSTELET Guest

    Le 24/07/2003 07:53:32, "Christian HOSTELET" a écrit:
    Hello again,

    An for PCB production (proto), Olimex (www.olimex.com)
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Which MC should I get?

  2. Which relay should I use?

  3. Which relay should I use?

  4. Which motor should I use ?

  5. Which capacitor should I use???

  6. which microcontroller should i use ?

  7. Stuff I can get but should I?

  8. Which Microcontroller should I use for my project?

Loading...
Electronics Point Logo
Continue to site
Quote of the day

“”

-