If you have more time than money and the circuit has not been prototyped you
are probably best advised to wire wrap the first board to make sure it
works.
There are some small Chinese PCB manufacturers that sell cheap, but never
really tryied them, so I am not sure if the quality of the PCBs that they
produce follows an inverse law with respect to how much they cost you, which
I assume is not the case. Just Google
1) You have to use THEIR software.
Anything done up to this point will have to be redone in their program.
2) Their software does NOT allow easy printing to document your work.
3) Their software does NOT produce gerbers, making it LOCK-IN-WARE