Connect with us

What's changed in CRT display in the last decade?

Discussion in 'Electronic Basics' started by ~Dude17~, Aug 29, 2004.

Scroll to continue with content
  1. ~Dude17~

    ~Dude17~ Guest

    X-No-Archive: Yes

    I know things are ALWAYS changing for the computer itself, but I
    figure television /CRT technology is pretty much matured.

    You can get a 19" CRT for $200 today that has a completely flat tube.
    I remember high end 17" CRT PC monitors were over $1,000 in 1995.
    What was so different back then?
     
  2. Gene

    Gene Guest

    The advent of flat panel displays is putting price pressure on the CRT's.
     
  3. Spajky

    Spajky Guest

    mass production , strong competition & price "wars"?
     
  4. Bob Myers

    Bob Myers Guest

    Far more integration than before; digital control/generation
    of waveforms (such as the geometry, focus, and convergence
    correction; a LOT more use of the plastic case parts as
    structural supports as opposed to a metal frame to which the
    case AND PC assemblies were attached; much less labor
    (esp. through automated adjustment processes), and what
    there is is in lower-cost regions (i.e., assembly in mainland
    China or Malaysia rather than Japan or Korea); and lower-cost
    components (and, thanks again to the increased integration,
    fewer of them).

    If you can find monitors from, say, 1980 and 1990, and open
    them up alongside a current product, you'll see the differences
    very clearly. However, don't expect the trend to continue - there's
    very, very little in the way of further development of CRT
    monitor design or production processes going on any more.

    Bob M.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-