Maker Pro
Maker Pro

What pots are used in these schematics?

T

Tom

Jan 1, 1970
0
There are several push/pull pots in the following schematics.
Can anyone tell me what values they are? I need to replace a
couple of them. I can't tell just from looking at them - there
doesn't seem to be enough writing on them to identify them.
I'm hoping the schematics and components list will help.

Note: There are also some non-push/pull pots listed. Those I
don't need .. just the push/pull pots.

Thanks

schematic part 1:
http://img593.imageshack.us/img593/761/bedrock1600schematic1.jpg
schematic part 2:
http://img39.imageshack.us/img39/476/bedrock1600schematic2.jpg
circuit layout:
http://img9.imageshack.us/img9/2347/bedrock1600circuitlayou.jpg
components list:
http://img269.imageshack.us/img269/808/bedrock1600componentsli.jpg
 
P

Phil Allison

Jan 1, 1970
0
"Tom"
There are several push/pull pots in the following schematics. Can anyone
tell me what values they are? I need to replace a couple of them. I
can't tell just from looking at them -


** You own a multimeter ??

It is easy to measure the value and taper with the ohms range.



... Phil
 
Top