Connect with us

Weller EC1002

Discussion in 'Electronic Equipment' started by mbhelect, Dec 6, 2003.

Scroll to continue with content
  1. mbhelect

    mbhelect Guest

    Would like some help in repairing my Weller EC1002 soldering station.It will
    run the EC1302A iron but not the EC1201a iron.Any help would be greatly
    appreciated.

    Bill
     
  2. Jon Elson

    Jon Elson Guest

    If the temp sensor goes open, you get a reading of 959 F or something
    wild like that,
    and no heat. The sensor is pretty expensive. If your iron has 2 gold
    pins in the
    connector, measure between them with an ohmmeter. If it reads infinity, you
    need a new sensor. You can compare the two irons.

    Jon
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-