Connect with us

VREF pin - LEM HLSR Series Current Sensor

Discussion in 'Sensors and Actuators' started by DHARITRI HAZARIKA, Jul 10, 2017.

  1. DHARITRI HAZARIKA

    DHARITRI HAZARIKA

    1
    0
    Jul 10, 2017
    Hello Everyone,

    I am new to the LEM HLSR series current sensor series. If anyone have used or knows about the sensor can you please help me in below point.:4

    The LEM HLSR 10-p series can measure current of +-25A, with an output voltage of +-2V, But in the datasheet of the HLSR 10-P, there is one pin VREF, for overdriving the current measurement capability of the sensor. I don't need this feature, so can anyone suggest what to do with the VREF pin, should I leave it floating ?


    Thanks & Regards,
    Dharitri Hazarika
     
  2. kellys_eye

    kellys_eye

    4,281
    1,144
    Jun 25, 2010
    Looks like Vref is a 'requirement' whether you want it or not as it is used to calibrate the output.

    Suitable volt-drop resistor combination across the supply line and with a multi-turn preset to set.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-