Connect with us

Voltage reduction question?

Discussion in 'General Electronics Discussion' started by gunlocators, Dec 30, 2014.

Scroll to continue with content
  1. gunlocators

    gunlocators

    11
    1
    Dec 4, 2014
    I am working on a project that I want to use a battery pack that is 7,4v 1800mah to power a board for a ecig project that has the below specs what would you suggest to lower the voltage to a safe level to run the board.Basically I gutted a Handheld radio and building a ecig out of it but wanted to use the existing battery so this would be rechargable and have same look and feel as if it was still a real radio.....

    EVOL DNA 30 Board Specs
    Output Power min7 Watts max30 Watts
    Output Voltage min 4 Volts max 8.3 Volts
    Output Current 10 Amps
    Input Voltage min 3.2 Volts typical 3.7 Volts max 4.3 Volts
    Input Current min 1.5 Amps typical 6.0 Amps max12 Amps

    Board http://www.evolvapor.com/datasheet/dna30.pdf
    Battery http://www.amazon.com/Original-BaoF...id=1419951407&sr=8-2&keywords=baofeng+battery
     
  2. davenn

    davenn Moderator

    13,671
    1,892
    Sep 5, 2009
    hi
    welcome :)

    I have no idea what an ecig is and specifically what was used from the radio ??
     
  3. gunlocators

    gunlocators

    11
    1
    Dec 4, 2014
    The plastic case of the radio was used just need voltage reduction suggestion from batter volts
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-