Connect with us

Virtual reality magnetic position tracker help

Discussion in 'General Electronics Discussion' started by juanfhj, Oct 26, 2010.

Scroll to continue with content
  1. juanfhj

    juanfhj

    3
    0
    Oct 26, 2010
    Hi. I'm working on a virtual reality magnetic position tracker for motion capture. I wrote about it in Circuit Cellar 133, and I'm planning to improve it (you can check it out at ).

    Basically I have to measure very tiny magnetic fields. In the current tracker, the user is inside a cube with strong fields. For the next version I want to have a small magnetic field generator instead.

    For this, I have to measure tiny magnetic fields with field sensors. Now, these sensors have a lot of noise, so I need to filter the signal. It's not straightforward, cos the circuit operates at 100 kHz, so no active filters here. I thought switched capacitor, which would be the first time I try my hand at it.

    Sure there is the standard switched cap schematics, but these don't take advantage of the fact that the phase of the input signal is known. So I'm trying to figure out a custom switched cap circuit that uses this information. Some sort of variation on the LMF100.

    Basically I want to charge the capacitors in tune with the generated magnetic fields. I thought a custom topology could achieve this, rather than going for a generic design.

    Any pointers to an appnote or something? I also can mail a copy of the article to anyone interested.

    Thanks

    Juan Herrera
    Grad student
    Universidad EAFIT
    Colombia
     
  2. juanfhj

    juanfhj

    3
    0
    Oct 26, 2010
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-