B
Bgreen22
- Jan 1, 1970
- 0
I've installed a single pole motion detecting switch in my kitchen. Before
I had 2 toggle switches controlling 2 seperate overhead lights. What I
wanted was for my new switch to turn them on and off together, so I simply
combined the coresponding wires from the 2 switched with the new switch.
It works fine, but I am a little worried. Is this okay? Am I running too
much current through the switch?
Any advice is appreciated....
I had 2 toggle switches controlling 2 seperate overhead lights. What I
wanted was for my new switch to turn them on and off together, so I simply
combined the coresponding wires from the 2 switched with the new switch.
It works fine, but I am a little worried. Is this okay? Am I running too
much current through the switch?
Any advice is appreciated....