Connect with us

USB to Parallel port programming

Reply to Thread

Discussion in 'Microcontrollers, Programming and IoT' started by eptheta, Nov 12, 2010.

Scroll to continue with content
  1. Nov 12, 2010 #1
    eptheta

    eptheta

    188
    0
    Dec 20, 2009
    I found an old USB to 25 pin parallel port converter. I wanted to use it to program my Atmega16s which i normally program using a parallel port on my old desktop.

    However when plugged in i see that I can only use this for printers and nothing else.

    Is this a hardware issue or a software issue ?
    How can i get it working like a normal parallel port which i can use for programming?
    Thanks.
     
  2. Nov 12, 2010 #2
    (*steve*)

    (*steve*) ¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd Moderator

    25,271
    2,718
    Jan 21, 2010
    It may be a bit of both.

    The parallel port on a PC is programmable in all sorts of ways. You can basically address each of the pins and do stuff with them.

    The USB hardware may not have complete functionality in its parallel port emulation since it needs only to print, not to fully emulate the hardware. In addition it only has to provide protocols and firmware to do what it's designed to do.

    It sounds like your programmer is not acting as a printer and the additional functionality isn't supported by the USB hardware and/or software :-(
     
  3. Nov 12, 2010 #3
    eptheta

    eptheta

    188
    0
    Dec 20, 2009
    Yeah I went through a 100 links on Google, all saying the same thing....
    Is there anything I can do to make it work like a parallel port ? Or does the cable just go to waste ?
     
  4. Nov 13, 2010 #4
    eptheta

    eptheta

    188
    0
    Dec 20, 2009
    Hi,
    After much frustration I decided to assemble this:
    [​IMG]
    Taken from:Here !

    A few things confuse me.
    Why is pin 2 and 3 of the Atmega8 connected to the 10 pin socket if only 6 of those pins(excluding 2 and 3 of course) are going to be used as input to the microcontroller that has to be programmed ?

    Whats the point of the 4.7u capacitor attached to pin 1 of the USB port?

    Is JP1 necessary or is it just to power the other microcontroller when needed ?

    Thanks !

    14/11/10 -- Anybody ???
     
    Last edited: Nov 14, 2010
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. DB25 Parallel Port Programming

  2. PC Parallel port to led

  3. MATLAB code to control parallel port

  4. Software to control COM or Parallel port pin output

  5. New to pic programming

  6. help on programming ATMEGA16A using USB AVR Programmer

  7. programming language to program hardware

  8. Programming

Loading...
Electronics Point Logo
Continue to site
Quote of the day

“”

-