Connect with us

Universal Drill Motor Speed Control- help

Discussion in 'Beginner Electronics' started by Gerry OGrady, Oct 9, 2003.

Scroll to continue with content
  1. Gerry OGrady

    Gerry OGrady Guest

    8 October 2003 5:54 PM

    I have a 6 amp speed control removed from a universal brush type 120 volt
    A.C. Skil Reversible variable speed drill. This drill does not have
    permanent magnets, but a wire wound FIELD COIL and the speed control has
    specific wires going to the field circuitry. I have a 3 amp brush type 90
    VDC motor with a PERMANENT magnet field. Is there any way I can
    fool/modify/adapt the above speed control to reliably vary the speed of this
    permanent magnet 90VDC motor ? Reversibility is not required.

    Cheers... Gerry
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-