Connect with us

ultrasonic drill

Discussion in 'Electronic Basics' started by vinay, Oct 17, 2007.

Scroll to continue with content
  1. vinay

    vinay Guest

    hello to all group members,

    please tell me were i can get
    a small ultrasonic driller for drill holes in hard granite stones with
    the depth of 2 inches and the diameter of holes is 5m.m to 10 m.m.that
    driller must be able to carry by a men.
     
  2. An ordinary electric drill with a hammer option will do the job using
    tungsten carbide bits. You will need an inverter if you want to run the
    drill off a car battery. Are you collecting samples for analysis?

    R
     
  3. Jamie

    Jamie Guest

    How about a hammer drill ?

    May not do smooth work but it'll sure place a hole
    in that rock! :)
     
  4. Bob Masta

    Bob Masta Guest

    The OP should look into the drills that cavers use when
    placing climbing bolts. Cavers have *serious* constraints
    on battery weight/life, since the drill may need to be lugged
    for many hours through rugged passages to get to where it
    is needed.

    Best regards,


    Bob Masta

    DAQARTA v3.50
    Data AcQuisition And Real-Time Analysis
    www.daqarta.com
    Scope, Spectrum, Spectrogram, Signal Generator
    Science with your sound card!
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-