Maker Pro
Maker Pro

Two DIY questions.

C

carolinaoff

Jan 1, 1970
0
Have a 15P which I cannot get the "Low Battery" warning to clear. Read
on line about power up sequence, have replace it with a new battery,
tried charging externally and still the warning is there. Removed the
battery completely and used an external UPS and still the warning
displays. Any help appreciated.

Second item. Installed a second 6270 - is there any way to copy the User
Names from the old to the new or is that info stored separately in each
unit.

Thanks.
 
F

Frank Olson

Jan 1, 1970
0
Have a 15P which I cannot get the "Low Battery" warning to clear. Read
on line about power up sequence, have replace it with a new battery,
tried charging externally and still the warning is there. Removed the
battery completely and used an external UPS and still the warning
displays. Any help appreciated.

Second item. Installed a second 6270 - is there any way to copy the User
Names from the old to the new or is that info stored separately in each
unit.

Thanks.


Remove the second 6270 and see if that clears your problem. Like Mark
stated, you can't power two of these without an additional power supply.
 
C

carolinaoff

Jan 1, 1970
0
Check the battery fuse in the upper left hand corner of the board.

It was blown, Thanks. I assume it should charge after replacement.
 
Top