Maker Pro
Maker Pro

Tumble dryer power switch problem

M

Mike B

Jan 1, 1970
0
It's a Westinghouse LD505e
As from today I have to hold the power switch in all the time otherwise it
switches itself off. I used to be able to just press once for on, and again for
off. Other than that it works fine.

The power switch is non-latching so there's no visual indication of on/off other
than the LEDs and beeper.
Here's some pics.
Power switch is the brown thing on the right.
http://members.iinet.net.au/~mbuckler/tumble-dryer/pcb-right-and-power-switch.jpg

Reverse side showing power switch on left and control relays.
http://members.iinet.net.au/~mbuckler/tumble-dryer/power-switch.jpg

Transformer
http://members.iinet.net.au/~mbuckler/tumble-dryer/transformer.jpg

PCB middle
http://members.iinet.net.au/~mbuckler/tumble-dryer/pcb-middle.jpg

PCB left
http://members.iinet.net.au/~mbuckler/tumble-dryer/pcb-left.jpg

Does anyone have an idea of how to diagnose this?

Mike
 
M

Me2

Jan 1, 1970
0
HI Mike,
The power switch looks like it would be a latching type,
It has High current wires attached i.e. its not small signal type like would
be used to trigger relays/ electronics.
See if you can get hold of a new one and compare it.
If your sure its not that, check the door switch.
Best luck, don't kill your self, or burn the house down.
Allan
 
D

Dan

Jan 1, 1970
0
Mike B said:
It's a Westinghouse LD505e
As from today I have to hold the power switch in all the time otherwise it
switches itself off. I used to be able to just press once for on, and
again for
off. Other than that it works fine.

The power switch is non-latching so there's no visual indication of on/off
other
than the LEDs and beeper.
Here's some pics.
Power switch is the brown thing on the right.
http://members.iinet.net.au/~mbuckler/tumble-dryer/pcb-right-and-power-switch.jpg

Reverse side showing power switch on left and control relays.
http://members.iinet.net.au/~mbuckler/tumble-dryer/power-switch.jpg

Transformer
http://members.iinet.net.au/~mbuckler/tumble-dryer/transformer.jpg

PCB middle
http://members.iinet.net.au/~mbuckler/tumble-dryer/pcb-middle.jpg

PCB left
http://members.iinet.net.au/~mbuckler/tumble-dryer/pcb-left.jpg

Does anyone have an idea of how to diagnose this?

Diagnose what? it must be latching and its fucked
 
M

Mike B

Jan 1, 1970
0
HI Mike,
The power switch looks like it would be a latching type,
It has High current wires attached i.e. its not small signal type like would
be used to trigger relays/ electronics.
See if you can get hold of a new one and compare it.
If your sure its not that, check the door switch.
Best luck, don't kill your self, or burn the house down.
Allan

Pulled the switch apart (it turned out to be a latching type) and cleaned it.
I guess fluff or something got inside..
I was expecting it to be like the front panel switch in a computer which simply
carries a logic signal.
It's all working now.

Thanks

Mike
 
Top