4
427Cobra
- Jan 1, 1970
- 0
This unit came in with split image (r and l switched) and owner said
they may have changed quite a few settings in service mode (was
probably ADDR mode). OSD is fine, but all inputs are affected.
Performed QA02 reset and the screen cleared up. While trying to
restore original settings, ADDR mode came on again and after a few
seconds restarted the TV. After doing this a few times, the image was
split in two again. I searched the net and could not find any ADDR
codes. No, I don't have a service or schematic manual. It was
suggested it may need a new eprom. Thanks in advance,
Alex
they may have changed quite a few settings in service mode (was
probably ADDR mode). OSD is fine, but all inputs are affected.
Performed QA02 reset and the screen cleared up. While trying to
restore original settings, ADDR mode came on again and after a few
seconds restarted the TV. After doing this a few times, the image was
split in two again. I searched the net and could not find any ADDR
codes. No, I don't have a service or schematic manual. It was
suggested it may need a new eprom. Thanks in advance,
Alex
