Maker Pro
Maker Pro

Toshiba model 24AF44, Ch. M3M627 focus and luminence problem

The customer said that all of a sudden the screen went out of focus
and the brightness drastically reduced. Although I never suspected an
adjustment problem I tried the controls just to see. The flyback
screen control will raise the screen and the focus has some effect but
does not have sufficient range. I have no schematic for this set. I'm
thinking bad divider in the IHVT or is there perhaps an external
resistor in the divider circuit that might do this? Another respondent
suggested a possible focus to G2 short however there does not seem to
be one. Or does anyone know if this problem is common to this set?
Thanks. Lenny.
 
The customer said that all of a sudden the screen went out of focus
and the brightness drastically reduced. Although I never suspected an
adjustment problem I tried the controls just to see. The flyback
screen control will raise the screen and the focus has some effect but
does not have sufficient range. I have no schematic for this set. I'm
thinking bad divider in the IHVT or is there perhaps an external
resistor in the divider circuit that might do this? Another respondent
suggested a possible focus to G2 short however there does not seem to
be one. Or does anyone know if this problem is common to this set?
Thanks. Lenny.

I just wanted to add that after running for awhile I also noticed that
the flyback is quite hot. There doesn't seem to be any other
noticeable problems with the secondaries.Lenny.
 
J

Jamie

Jan 1, 1970
0
I just wanted to add that after running for awhile I also noticed that
the flyback is quite hot. There doesn't seem to be any other
noticeable problems with the secondaries.Lenny.
Replace the flyback.


--
"I'd rather have a bottle in front of me than a frontal lobotomy"

"Daily Thought:

SOME PEOPLE ARE LIKE SLINKIES. NOT REALLY GOOD FOR ANYTHING BUT
THEY BRING A SMILE TO YOUR FACE WHEN PUSHED DOWN THE STAIRS.
http://webpages.charter.net/jamie_5"
 
J

Jerry G.

Jan 1, 1970
0
Replace the flyback and HV multiplier assembly to start with. Most
likely this will fix the fault.

--

Jerry G.


The customer said that all of a sudden the screen went out of focus
and the brightness drastically reduced. Although I never suspected an
adjustment problem I tried the controls just to see. The flyback
screen control will raise the screen and the focus has some effect but
does not have sufficient range. I have no schematic for this set. I'm
thinking bad divider in the IHVT or is there perhaps an external
resistor in the divider circuit that might do this? Another respondent
suggested a possible focus to G2 short however there does not seem to
be one. Or does anyone know if this problem is common to this set?
Thanks. Lenny.
 
Top