Connect with us

Toshiba 32" TV Circa 1990 dead.

Discussion in 'Electronic Repair' started by Dani, Feb 6, 2008.

Scroll to continue with content
  1. Dani

    Dani Guest

    M # CX32630, Ch # TAC9035, dead 5 volts ok, 10.5 vdc @ relay, but
    relay won't energize. Cap on the relay is ok. Jump relay, set comes on
    with no vertical, just a line accross the screen. Vertical IC is ok,
    when set is on power supply runs ok. Is there anything common on this
    unit? Thanks, Dani.
  2. b

    b Guest

    you will need to troubleshoot the vertical section, how do you know
    the ic is ok, have you changed it? you may well have an open resistor
    in the supply rail or bad caps. If so, the set seems like it is in
    protection or the relay may be faulty. i replaced one the other day
    which clicked and everything, but did not make contact.

    check on for the schematic.

Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day