Connect with us

TI MicroLaser Plus paper feed

Discussion in 'Electronic Repair' started by Sam Goldwasser, Apr 14, 2005.

  1. It's old but prints very well. The only problem is that most of the
    time, the main paper feed from the tray jams. I've cleaned the rubber
    parts as best I can. The paper never seems to make it to the pickup
    roller after the 180 turn.

    Am I forced to use manual feed on this thing? :)

    Thanks.

    --- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
    Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
    +Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
    | Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

    Note: These links are hopefully temporary until we can sort out the excessive
    traffic on Repairfaq.org.

    Important: Anything sent to the email address in the message header above is
    ignored unless my full name is included in the subject line. Or, you can
    contact me via the Feedback Form in the FAQs.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-