Adam_randell
- Jan 23, 2014
- 2
- Joined
- Jan 23, 2014
- Messages
- 2
Hello all. Let me introduce myself, I am 24, a tattooist and looking to make tattoo equipment.
My first project is clip cords. This involves a 1/4 inch jack connecting which I have no problems with however the other end is a different story. It involves riveting a positive and negative connection. My issue is, that they are both riveted to a piece of metal coated in plastic but I am sure the rivet will connect with the metal and short circuit. Is there any way of insulating the rivets? I tried heat shrink but it didn't really take.
Any advise much appreciated
My first project is clip cords. This involves a 1/4 inch jack connecting which I have no problems with however the other end is a different story. It involves riveting a positive and negative connection. My issue is, that they are both riveted to a piece of metal coated in plastic but I am sure the rivet will connect with the metal and short circuit. Is there any way of insulating the rivets? I tried heat shrink but it didn't really take.
Any advise much appreciated