Hi Everyone, I cant seem to find any LED holder/bracket that would accomplish what im trying todo. This is a little off-topic, its not specifically electronic related, i just figure that with everyones experience in electronics and components/enclosures, someone may have come across something suitable. If not, im going to have to design one and have it custom made, which could get very expensive. I need LED's mounted on tables - these tables are expensive casino tables, so big messy holes are not an option. What im thinking is something like a little saucer (to cover the roughed up felt after drilling the hole), with the LED mounted in the middle (perhaps with a lense cap), and this saucer has a threaded pole (out side thread) about 10cm long, so a nut can be used under the table to secure it. (the wires running down the centre). I have been googling for ages and cant seem to find anything suitable to mount to a table top. If anyone has seen anything like this, or has any ideas ... Thanks again! Alex.