TA8445k vert ic keeps blowing on this tv

[aldo]

It had just a horizontal line, so i changed the vert ic and a resistor
0.68 ohm (open) and its diode (shorted) near flyback. Then i turn on
the tv and i had a normal picture for 2 seconds then horizontal line
again. Now when i turn on the tv i hear just flub-flub-flub-flub and
not even that horizontal line. Is that yoke busted? Any ideas?
Thanks

 

[Tom MacIntyre]

It had just a horizontal line, so i changed the vert ic and a resistor
0.68 ohm (open) and its diode (shorted) near flyback. Then i turn on
the tv and i had a normal picture for 2 seconds then horizontal line
again. Now when i turn on the tv i hear just flub-flub-flub-flub and
not even that horizontal line. Is that yoke busted? Any ideas?
Thanks

Make and model, FCC ID of the TV?

You had a vertical problem...you replaced some defective parts, but
did not identify the actual cause of the problem, you missed at least
one other defective part...you now have a second similar version of
the problem, but not identical to it.

How are the parts that you replaced? Did you use the correct parts
when you replaced them? Any solder bridges where you worked? What test
equipment do you have?

Tom