R
[email protected]
- Jan 1, 1970
- 0
need pinouts for qube 3 - unit needs 5, 12, and -12v power
I am unable to identify the supply lines.. I do know the grounds.
Known: the unit needs +5, +12, and -12 volts
unknown: which terminals on the 8 pin din connector is the 12, 5, and
-12.
USE: this number layout
http://freespace.virgin.net/tom.baldwin/DIN8-pinout.gif
I know pins 7,5,4 are connected to ground (chassis)
if someone here with a qube 3 could measure the pins it would be
greatly appreciated.
SEARCHED the web for this NO INFO anywhere to be found.
why couldnt the manufacturer supplied this fundamental info in their
user manuals .
post results here or at http://www.cobaltuserforums.com/viewtopic.php?t=567
I am unable to identify the supply lines.. I do know the grounds.
Known: the unit needs +5, +12, and -12 volts
unknown: which terminals on the 8 pin din connector is the 12, 5, and
-12.
USE: this number layout
http://freespace.virgin.net/tom.baldwin/DIN8-pinout.gif
I know pins 7,5,4 are connected to ground (chassis)
if someone here with a qube 3 could measure the pins it would be
greatly appreciated.
SEARCHED the web for this NO INFO anywhere to be found.
why couldnt the manufacturer supplied this fundamental info in their
user manuals .
post results here or at http://www.cobaltuserforums.com/viewtopic.php?t=567