Connect with us

Suggestions on molded , shielded, cabling system

Discussion in 'General Electronics' started by qu1nn, Jul 22, 2004.

  1. qu1nn

    qu1nn Guest

    Hello,

    Does anyone have suggestions supplier of cable assemblies that would
    meet the following requirements:

    4 conductor, small overall diameter (<0.25"), 20-24AWG stranded
    Shielded
    IP 67
    right angle circular connector one end, wire the other end.
    ~ 1.5m length,



    I was looking at the lumberg RKMWV series.
    Just looking for alternatives.

    Thank you for your time
    qu1nn
     
  2. Sporkman

    Sporkman Guest

    You need a harness maker with overmolding capabilities. It has been a
    long time since I used such services, but I remember one with whom I had
    good results and good cooperation. They were CEA Technologies, Inc
    located in Colorado Springs (www.ceatechnologies.com). I have no
    current business relationship with them and no vested interest either.

    Mark 'Sporky' Stapleton
    Watermark Design, LLC
    www.h2omarkdesign.com
     
  3. qu1nn

    qu1nn Guest

    Scrap the 4 conductor I need 7 conductor, the overall dia can increase a bit
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-