Maker Pro
Maker Pro

Stupid question of the day!

Bacdoc13

Dec 1, 2014
10
Joined
Dec 1, 2014
Messages
10
Hi all,
Want to use a four prong tactile switch on a board. Not sure how one would know pin number by looking at them. Also, how would one know how to assemble board (through hole) from a board design? Is there a way to know which is pin one and which is pin four by looking at it and how does assembler know.
Thanks!
 

Minder

Apr 24, 2015
3,478
Joined
Apr 24, 2015
Messages
3,478
If you are talking about the PCCT 4 pin SP PB they always have continuity across each of the wide pairs, when pushed both these wide pairs are connected together.
M.
 
Top