Connect with us

Stepper phase windings

Discussion in 'Electronic Basics' started by news.earthlink.net, Nov 20, 2004.

Scroll to continue with content
  1. I have a lot of small stepper motors with 16 leads (8 pair of windings). Is
    there some procedure I can go through to find the phase order of the
    windings. I mean, I need to apply power to these windings, in order, so that
    the motor will move in the most efficient manner. I tried an oscilloscope on
    one set of leads while generating a sinusoidal signal on another but the
    difference in inducted voltage was not enough to tell me which set of leads
    was closest to the one into which I was generating the signal.
     
  2. David Harmon

    David Harmon Guest

    On Sat, 20 Nov 2004 15:54:03 GMT in sci.electronics.basics,
    Spin the shaft and observe the induced voltages on the windings?
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-