Wanted: Stepper motor

[mregan]

Hi!
I'm looking for a mitsumi m35sp-9t Stepping Motor for use in an HP M2727 MFP printer. The apparently come in several flavors: I need a 10 OHM, with a 5-pin connector, not the ribbon cable version. If anyone can help I'd be very grateful. These things are incredibly un-findable. I can be reached at [email protected].
Thanks,
Mike

 

[DB Tech]

Is this the scanner motor? If so it has a high failure rate. Look for Q3984-60186-B. This is unconfirmed data I received from someone else. After you replace it you may have to swap out the formatter also. Motors I have seen were frozen solid had to use a vice grip on em to even get them to move. They may have sat too long in a dock and may have gotten damp.

 

[jackorocko]

I have one of these, but it is not a unipolar stepper. Mine is a 4 wire bipolar 11Ohms. This is the one you don't need?