Connect with us

SR32.4VLZPro repair

Discussion in 'Troubleshooting and Repair' started by daverro, Jun 13, 2013.

Scroll to continue with content
  1. daverro

    daverro

    4
    0
    Jun 13, 2013
    Hello, I have a question about a component on a Sound mixing board (SR32.4VLZPro) . I have the schematics an a picture and was wondering if you can help me identify the component. thanks.
     

    Attached Files:

  2. (*steve*)

    (*steve*) ¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd Moderator

    25,497
    2,838
    Jan 21, 2010
    It's a small capacitor. I'd need a clearer view of the device (or you can tell me what the writing says) before I can tell you more.
     
  3. daverro

    daverro

    4
    0
    Jun 13, 2013
    Hello,

    How can I attach more photos for you to view. The writing on the component is very hard to see, here is what I believe it is:

    SE
    103

    MBB
    Y37

    thanks!
     
  4. (*steve*)

    (*steve*) ¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd Moderator

    25,497
    2,838
    Jan 21, 2010
    probably 0.01uF (or 10nF)
     
  5. daverro

    daverro

    4
    0
    Jun 13, 2013
    thank you! I will test it with that in mind.
     
  6. daverro

    daverro

    4
    0
    Jun 13, 2013
    Hello,

    tested it. When i put the multi reader on 20nf, i get a reading of 9.97. I assume it is a good capacitor.

    One thing I noticed though. I get pretty much the same ready when I swap the ends of the multi reader leads. any issues with that?

    thanks
     
  7. (*steve*)

    (*steve*) ¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd Moderator

    25,497
    2,838
    Jan 21, 2010
    Sounds fine. Any reading from 9 to 11 nF would be expected. 9.97 means it's remarkably close to the marked value.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads
There are no similar threads yet.
Loading...
Electronics Point Logo
Continue to site
Quote of the day

-