Connect with us

speed control for steam engine

Discussion in 'General Electronics Discussion' started by james c, Mar 13, 2012.

Scroll to continue with content
  1. james c

    james c

    1
    0
    Mar 13, 2012
    I need someone to design a circuit for me. It is a speed control for a 25hp steam engine. I already have safety featured built into the mechanical design. This speed control will operate a 4 amp 12 volt linear actuator which will operate the steam valve adjusting steam volume into the cylinder. The circuit needs to be 12 volt. I need an RPM controlling rheostat and a rheostat also for a sensitivity/delay control so the valve isn't moving too much for every little change. RPM of the engine will be around 150 + or - 10% is good. A magnet can be placed on the flywheel and a magnetic pickup sensor can be used unless you have a better way.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-