Maker Pro
Maker Pro

SPDT tact switch

Anyone have any advice about finging an ultra low-profile SPDT switch?
I need it to be <2mm tall, with a feel similar to a small tact switch.


There are plenty of SPST tact switches out there. I can think of a
simple design for an SPDT tact switch using the same snap domes that
are in the SPST's, but no one makes them. :( Maybe I should patent it.

Any help is much appreciated.
 
L

Luhan

Jan 1, 1970
0
Anyone have any advice about finging an ultra low-profile SPDT switch?
I need it to be <2mm tall, with a feel similar to a small tact switch.


There are plenty of SPST tact switches out there. I can think of a
simple design for an SPDT tact switch using the same snap domes that
are in the SPST's, but no one makes them. :( Maybe I should patent it.

Any help is much appreciated.

This looks like a dead end node on your design tree. Back up one.
Can't you design with a common part like the SPST? Or, at least tell
us why you need the SPDT.

Luhan
 
Top