C
[email protected]
- Jan 1, 1970
- 0
Set came in with "just clicks" complaint. Customer says that it had
been cutting off after about 15 minutes for a while until it went out
for good. The hor. output a 2SC5426 is shorted . I planned to go over
the soldering however I was advised by another tech. that I should
also look for a bad cap (he wasn't sure if it was an electrolytic or
perhaps a mylar) in the supply circuit as well. Does anyone know if
there is any further information on this set? Thanks, Lenny Stein,
Barlen Electronics.
been cutting off after about 15 minutes for a while until it went out
for good. The hor. output a 2SC5426 is shorted . I planned to go over
the soldering however I was advised by another tech. that I should
also look for a bad cap (he wasn't sure if it was an electrolytic or
perhaps a mylar) in the supply circuit as well. Does anyone know if
there is any further information on this set? Thanks, Lenny Stein,
Barlen Electronics.