Connect with us

Solderless proto board hook up wire?

Discussion in 'Electronic Basics' started by Chris W, Feb 23, 2005.

Scroll to continue with content
  1. Chris W

    Chris W Guest

    Does anyone make any ribbon with between 2 to 20 wires that will work
    with the .1" spacing on the solderless breadboards? That would be
    really handy for hooking the BCD output of one chip to the input of
    another. Also it would be nice to have some kind of ribbon cable with a
    female connection on one side and make connection on the other that
    could be used to hook to a 2 x 20 pin header of some pre-built board to
    a breadboard. The header I am looking at already has a .1" spacing, but
    the 2 columns are also .1" apart so unless there is a breadboard layout
    that I don't know about, plunging it into one will hook each row of 2
    pins together, which is very unlikely to be what I need to do.

    --
    Chris W

    Gift Giving Made Easy
    Get the gifts you want &
    give the gifts they want
    http://thewishzone.com

    "They that can give up essential liberty
    to obtain a little temporary safety
    deserve neither liberty nor safety."
    -- Benjamin Franklin, 1759 Historical Review of Pennsylvania
     
  2. Rich Webb

    Rich Webb Guest

    Check Digikey for DIP form-factor IDC connectors. They're available
    pre-wired or as a bare connector, 14 to 40 pins in "DIP spacing" so they
    fit well on breadboards.

    Try this link, or just search on "IDC DIP connector"
    http://rocky.digikey.com/scripts/ProductInfo.dll?Site=US&V=32&M=CWR-130-16-0003
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-