Connect with us

SMT Operator

Discussion in 'Electronic Repair' started by [email protected], May 16, 2007.

Scroll to continue with content
  1. Guest

    Hi, Anybody here been or know what being an SMT operator in a factory
    setting is about? I have much experience with through hole soldering
    in a repair shop, but have never worked in a board factory. Think any
    of my experience in repair would be of use there? Thanks if you are
    replying, Sincerely, Allan
     
  2. Loading reels of components in an autoloader I assume.
     
  3. Guest

    Most likely loading components, maybe some touch up and correction of
    machine errors, knowing the polarity and orientation and the different
    types of SMT components wiil be key to success. Maybe some alignment
    inspection and board handling.

    http://www.circuittechnology.com
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-