Maker Pro
Maker Pro

SMD component identificatin

A

addis

Jan 1, 1970
0
I realized that on the electronic PCB in my AEG Lavamat 86730 washing
mashine one SMD component was damaged due leakage of the water. I am
not able to identify it. Photos are available on the web:
www.demosite01.com/AKO1.jpg
www.demosite01.com/AKO2.jpg
There is just AKO sign in the plastic.

Thanks for any information.
 
E

Eric

Jan 1, 1970
0
I think you are a funny guy, can you not get a closer picture.







I realized that on the electronic PCB in my AEG Lavamat 86730 washing
mashine one SMD component was damaged due leakage of the water. I am
not able to identify it. Photos are available on the web:
www.demosite01.com/AKO1.jpg
www.demosite01.com/AKO2.jpg
There is just AKO sign in the plastic.

Thanks for any information.
 
A

addis

Jan 1, 1970
0
OK, replaced with larger ones.
BTW, it seems to me this could be just bridge over the other lines on
the PCB.
 
N

NSM

Jan 1, 1970
0
| OK, replaced with larger ones.
| BTW, it seems to me this could be just bridge over the other lines on
| the PCB.

That'd be my guess. Have you used a meter on it?

N
 
A

addis

Jan 1, 1970
0
Yes, I did. I replaced the false component (one output was totaly
rusted with isoleted wires and installed the PCB back into the machine.
Wow, it is running again. So this plastic box was really just an
isolated bridge over the other routes on the PCB.
 
N

NSM

Jan 1, 1970
0
| Yes, I did. I replaced the false component (one output was totaly
| rusted with isoleted wires and installed the PCB back into the machine.
| Wow, it is running again. So this plastic box was really just an
| isolated bridge over the other routes on the PCB.

Doing it that way let them use an automatic installer. Probably cheaper than
adding a layer to the board.

N
 
Top