Maker Pro
Maker Pro

Simple simulation in Circuit Maker ?

C

Chaos Master

Jan 1, 1970
0
In an arcane spellbook written by the priests, labeled 'Posts of
sci.electronics.cad' I found a message from
Abbie[[email protected]]:
I am trying to simulate a simple led on/off astable on circuit-maker.
The diagram is here

http://wwwwww.users.btopenworld.com/test.wmf

My problem is that the simulation always seems to stop after 5 useconds
which doesn't let me see how the scr goes on and off. Am I expecting too
much from this software or am I just not using it correctly ?

http://wwwwww.users.btopenworld.com/Image1.gif

You can change the end time of the simulation. I don't remember the exact
commands for the CircuitMaker program, however.
 
A

Alain LAFON

Jan 1, 1970
0
In the Transient Analysis Setup window, you must to activate the UIC
(Initial Condition).
But, your schematic is unable to run as an astable oscillator for several
reasons.
And the SRC and also the LED need more current to work
 
Top