Maker Pro
Maker Pro

Simple Project? Need help

JoshE93

Aug 25, 2011
1
Joined
Aug 25, 2011
Messages
1
Hi, new to the forum need a little bit of help.

I want to make my own LED light strip, i think that it will be quite simple just need help. I have some electronics knowledge as i have just completed my BTEC National Diploma in Electrical Electronic Engineering.

Would it be sensible letting the LED's run off battery power i only want a strip of about 5 or 6, if so whats a suitable voltage battery. Also would it be suitable soldering the LED's on to a veraboard strip in series or parrallel.
 
Top