Shorted HOT on mits vs6015r?

[BFriedl]

Okay...I just fixed my power supply and put it back in the set to try it
out and with the 75w bulb, got +131v on B+, but when it was in the set,
got +1.2v. Seems that power supply still is sick? Replaced all of Bill's
recomendations already, and checked ic900, and ic950, all seemed to be ok.

--Brian

 

[GPG]

Okay...I just fixed my power supply and put it back in the set to try it
out and with the 75w bulb, got +131v on B+, but when it was in the set,
got +1.2v. Seems that power supply still is sick? Replaced all of Bill's
recomendations already, and checked ic900, and ic950, all seemed to be ok.

--Brian

There does not appear to be anything wrong with psu apart from the way
it has been treated. Do a simple resistance check from the B+ input to
the board and
circuit ground. It should be high. A low reading indicates a problem.
Disconnect the HOT collector and compare.