Maker Pro
Maker Pro

SHARP VERTICAL TURNTABLE ADVICE?

B

b

Jan 1, 1970
0
I am looking at replacing the belts on this early 80s VZ-3000 vertical
turntable; looks like it is going to be no picnic. The whole deck is
buried below masses of plastic mountings and circuitry. Was wondering
if any brave soul has already successfully performed this operation
and could advise on
a) tips on disassembly or where to find a service manual
b) main belt dimensions.

Regards
-B.
 
C

Colin Horsley

Jan 1, 1970
0
b said:
I am looking at replacing the belts on this early 80s VZ-3000 vertical
turntable; looks like it is going to be no picnic. The whole deck is
buried below masses of plastic mountings and circuitry. Was wondering
if any brave soul has already successfully performed this operation
and could advise on
a) tips on disassembly or where to find a service manual
b) main belt dimensions.
I did one 10 years ago. Main belt part number is NBLTH00080AFOO, don't know the
size.
Loading belt is 46x1.2mm. Good luck. Colin
 
Top