serial driven trigger...

[winstonsmith]

Hello,

Basically, I need to "pull" the trigger on a paintball gun with my
serial port. The gun has an electronic triger system installed, and all
I need to do is circumvent the pushbutton switch inside the handle...

I'm a total novice, and after some time searching, I haven't found any
relevant websites or schematics. Anyone have any ideas, or suggestions
for places to look?

 

[Si Ballenger]

Hello,

Basically, I need to "pull" the trigger on a paintball gun with my
serial port. The gun has an electronic triger system installed, and all
I need to do is circumvent the pushbutton switch inside the handle...

I'm a total novice, and after some time searching, I haven't found any
relevant websites or schematics. Anyone have any ideas, or suggestions
for places to look?

You can do it with a resistor and an NPN transistor. Just put the
transistor in parallel with the switch similar to the IR remote
button on the below page.

http://www.geocities.com/zoomkat/irmods.htm

 

[winstonsmith]

Well, that seems easy enough. I assumed it would be, but was unsure if
I should be taking extra care not to introduce any extra current into
the circuitboard of the trigger... I assume this is accounted for?

Thanks for the reply...

 

[Paul Burke]

You can do it with a resistor and an NPN transistor. Just put the
transistor in parallel with the switch similar to the IR remote
button on the below page.

If the switch is grounded that is. Otherwise use something like a solid
state relay, say LH1540 or similar.

Paul Burke

 

[winstonsmith]

How about this idea... instead of trying to circumvent the trigger
(space inside the handle is a huge factor), I'll switch the battery on
and off and adjust the trigger such that it's always depressed. I think
I have an idea of what this would look like, but unsure... any comments
on how this would be different?