Connect with us

Sencore SC3100 / Oscilloscope

Discussion in 'Troubleshooting and Repair' started by Jana617, Jul 17, 2018.

  1. Jana617

    Jana617

    1
    0
    Jul 17, 2018
    The trace would disappear after 15 min. Determined the problem in "High Voltage Board 1000". The Sencore replace a resistor with a MOV. Schematic shows it (was) as a 1 ohm 1 watt resister. Blowing cool air across it trace returns. I can not figure the marking on the MOV.....It states one side -XX72 X0XO other side GFCB China. I called Sencore. No help.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-