Connect with us

Searching for a certain LC-Display

Discussion in 'Electronic Components' started by Reinhard Zwirner, Mar 4, 2007.

Scroll to continue with content
  1. Hi

    It would be great if any of you experts knew a source for the
    following 3 1/2 digit LCD (it belongs to a Metrix MX 522 DMM):

    _______________________________________________
    | _____ _____ _____ |
    | I I I I I I I |
    | <-- I I I I I I I |
    | ___ I I_____I I_____I I_____I |
    | I I I I I I I |
    | BAT I I I I I I I |
    | I # I_____I # I_____I # I_____I |
    |_____________________________________________|
    |_I_I_I_I_I_I_I_I_I_I_I_I_I_I_I_I_I_I_I_I_I_I_| <- contacts


    Height of the digits is 1/2" (about 13 mm). The LCD gets
    connected to the PCB via zebra stripe type conducting rubber.

    TIA

    Reinhard
     
  2. TT_Man

    TT_Man Guest

    Most likely a totally custom device.
     
  3. However, an almost identical LCD is relatively easy to get,
    look in the usual component suppliers in your country.
    These are almost always single backplane LCDs with one pin
    per segment. Assuming this is a 1-off replacement, then get
    one with pins rather than zebra strip, and wire it up by
    hand.

    I replaced the LCD in a Keithley multimeter, the original was
    all black (I think someone left it in the thermal chamber while
    temperature testing the machine it was connected to.)
    The replacement (I think it came from Maplins in the UK) has
    "LOBAT" and "+" instead of "BATT", "-" and "~" on the left
    but is quite usable as a replacement (I wired the ~ wire for
    AC reading to the top&bottom segments of the + so it now
    says : for AC which is fine).

    Mike.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-