Maker Pro
Maker Pro

sanyo tv problem

S

Spuzva

Jan 1, 1970
0
In last two days TV shut down, LED blinks two times. I have turn it
off by main switch, and turn it on, TV works normally.
What is that fault code and how to get in service manu?

TV is Sanyo 29 FFV2-F
 
K

kip

Jan 1, 1970
0
Why dont you just diagnose the fault using say a DVM.
Also check for bad solder joints first.


kip
 
B

b

Jan 1, 1970
0
Spuzva said:
In last two days TV shut down, LED blinks two times. I have turn it
off by main switch, and turn it on, TV works normally.
What is that fault code and how to get in service manu?

TV is Sanyo 29 FFV2-F

this is almost certainly nothing to do with the service menu. Diddling
about with that will not only be of no use in solving this, but will
probably make things worse, if you don't know what youre doing (which
from your post seems a possibility). Take kip's advice and do some
testing and careful visual observations!
B.
 
S

Spuzva

Jan 1, 1970
0
kip je napisao/la ovo:
Why dont you just diagnose the fault using say a DVM.

what is DVM?
tv works when I turn it off and back on, and then works for day. i
suspect in cold solder joints, but I want to know is this led blinking
means
 
S

Spuzva

Jan 1, 1970
0
b je napisao/la ovo:
this is almost certainly nothing to do with the service menu. Diddling
about with that will not only be of no use in solving this, but will
probably make things worse, if you don't know what youre doing (which
from your post seems a possibility).

I know what I want to do, that have nothing with this error. I want to
slightly improve screen geometry

Take kip's advice and do some
testing and careful visual observations!

I will.
 
K

kip

Jan 1, 1970
0
Ok You suspect a cold solder joint !!
So pull out the chassis and start looking for them
I suggest you use a large mag glass its a lot easier.

kip
 
S

sofie

Jan 1, 1970
0
Spuzva:
I thought that you wanted to "fix" the intermittent power problem.... look
for the bad solder joints as Kip and b suggested. Who knows that could fix
your geometry problems.... hopefully so, because these low cost Sanyo
designs don't put a lot of effort into geometry correction..... in other
words, the service menu will not help much and most probably will get you in
trouble, so stay out of it until you fix the television.
 
J

JANA

Jan 1, 1970
0
I think you should take the set to a service shop. This is not something you
will be able to fix yourself!!!

--

JANA
_____


kip je napisao/la ovo:
Why dont you just diagnose the fault using say a DVM.

what is DVM?
tv works when I turn it off and back on, and then works for day. i
suspect in cold solder joints, but I want to know is this led blinking
means
 
Top