Maker Pro
Maker Pro

sansui g 6000 reciver

Status
Not open for further replies.

dougjscheuer

Nov 28, 2013
2
Joined
Nov 28, 2013
Messages
2
need help trying to figure out y power amp wont power up?checked all fuses unit was working fine turned it off then back on again about 5 min later all lights came on but the green power led it was still processing the input signal confirmed by spectrum display on my eq the secondary relay for the power amp is not clicking on power up please let me know any possible causes of this there is no burnt smell comming from the unit at all
 
Last edited:
Status
Not open for further replies.
Top