Connect with us

rotary walk behind lawn mower

Discussion in 'Electronic Equipment' started by callistus, Jul 20, 2004.

Scroll to continue with content
  1. callistus

    callistus Guest

    please i will like to know how a rotary walk behind lawn mower is
    produced and assembled.
    I am aMechanical Engineering student .
    Thanks
     
  2. Gnomes.

    Mike
     
  3. JW

    JW Guest

    I was going to say elves.
     
  4. Dan Fraser

    Dan Fraser Guest

    They cast metal, stamp metal, bend metal and they assemble all the bits and
    pieces.

    If you're any good as a Mech E student, you should be able to figure out a
    logical procedure just by looking at one.

    If in doubt, go to a used lawn mower shop, buy one. Tear it down to all the
    component parts. Then put it back together. If it runs again, you know the
    answer to your question.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-